There also is an air delivery system that consists of pipe or hose that is designed to adequately deliver compressed air at the correct flow rate and pressure to the plasma cutting system. The ...

Modern machines tend to use compressed air. If you already have a compressor you would like to use with your plasma cutter, you’ll need to check both PSI (pressure in pounds per square inch, and ...

Hobart's new AirForce 250ci is a plug-and-use plasma cutter, and it features an internal compressor so it's not necessary to hook up to an external air source.

Designed for on-site maintenance, the Tomahawk 375 Air plasma cutting system cuts mild steel, stainless steel and aluminum. It includes an internal air compressor and can be used anywhere 208- or ...

Hobart has just released two new portable air plasma cutters. The AirForce 500i which can cut though a 5/8 inch piece of steel, and the AirForce 700i which will cut though a piece of 7/8 inch ...

The Tomahawk 375 Air plasma cutting system line can be used anywhere 208- or 230-volt, single-phase, 60-Hz power is available. Produces 10- to 25-amp output and is rated at 25 amps at 90 volts, 35 ...

Air Vantage 500 is a welder, generator and air compressor in one. The compressor is rated to produce 60 cubic feet per minute at 100 psi 100 percent duty cycle for arc gouging, plasma cutting or air ...

The tip in the plasma cutter is a consumable, and it will have to be replaced occasionally, and if you can’t buy fitting tips, then the whole machine becomes useless. And there are a lot of ...